Mar 16, 2023 Leave a message

How to put an end to diamond compound bit slime?

Diamond composite bit is more and more widely used in modern drilling operations, but in the process of use often for such problems, today from the following two aspects to tell you how to prevent diamond composite bit mud coating phenomenon.


A. Mud performance adjustment

1. Mix oil or increase lubricant input, so that drilling cuttings are not easy to adhere to the drill bit;


2. Increase the polymer content in drilling fluid, control water loss and improve the quality of mud cake;


3. Improve the inhibition of drilling fluid and reduce the hydration dispersion of mud shale;


4. Reduce the viscosity and shear force of drilling fluid and remove the inferior solid phase in time;


5. For high permeability sand layer, shielding temporary plugging technology can be used to reduce permeability leakage;


6. The paste bearing rock, should be added in advance alkali, to prevent its pollution of mud.


7. It is effective to maintain and handle the mud properties before and after the diamond composite bit is put into the well to prevent the diamond composite bit mud coating; After drilling the diamond composite bit and before starting the pump, a certain amount of cleaning agent (surfactant) is configured to clean the diamond composite bit.


B. Engineering and technical measures for oil drilling equipment

1) Firstly, the selection of diamond composite bit should be done well, and the design of water hole and flow channel of diamond composite bit should be conducive to chip removal;


2) Before running the diamond composite bit, the mud should be fully circulated to clean the hole to prevent the drilling cuttings remaining in the hole after drilling from continuing to hydrate and disperse;


3) Before running the diamond composite bit, make a short trip to scrape and extrude the wall mud cake, and stretch and compacted the thick mud cake to ensure the smooth borehole and eliminate the blockage; In areas with high incidence of diamond complex bit mud coating, if all methods cannot avoid diamond complex bit mud coating, it is necessary to run the well with a cone bit first


4) When drilling, the surface of the diamond composite bit runner is coated with butter to form a protective film, to reduce the time of direct contact between the bit and the inferior solid phase in the mud, or to wrap the diamond composite bit, which even has a certain role in deep Wells;


5) During drilling, the diamond composite bit continuously scrapes the well wall, and the mud cake on the well wall or the drilling cuttings remaining in the well will accumulate under the bit. To a certain extent, it will be pressed onto the diamond composite bit, so it is necessary to carry out a cycle in the middle of drilling to wash the diamond composite bit;


6) In the process of drilling, the speed should be properly controlled to prevent the drill bit from suddenly punching into the sand bridge and drilling into a pile of mud; In addition, at the right speed, the bit follows the spiral trajectory of the previous bit, rather than pulling mud cakes down the wall.


7) When drilling to the bottom each time, start the pump, and try to increase the displacement to fully wash the bottom hole and drill bit. After the displacement meets the requirements, light pressure rotary drilling is performed at 0.5-1m, which is also the requirement of diamond composite bit modeling.


8) Use large displacement drilling as far as possible to ensure adequate cleaning and cooling of diamond composite bit;


9) To drill in soft mudstone, low weight on bit, high speed and large displacement should be adopted as far as possible. There is no need to blindly use high weight on bit to pursue the drilling rate of only a little bit higher, which is just the use of cone bit.


10) The operation should be fine, and the drill feeding pressure must be uniform, not sudden or sudden.

The above is how to prevent the phenomenon of diamond composite bit mud bag, hope that the majority of customers in the future when using diamond composite bit to prevent.


Send Inquiry

Home

Phone

E-mail

Inquiry